Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wallace [2012/07/07 21:23] domonoky |
wallace [2012/10/27 00:01] bonsaibrain [Parts] |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| *[[http://www.2printbeta.de/product_info.php?language=en&products_id=67|RAMPS 1.4 electronics set]] | *[[http://www.2printbeta.de/product_info.php?language=en&products_id=67|RAMPS 1.4 electronics set]] | ||
| *[[http://www.2printbeta.de/product_info.php?language=en&products_id=66|RAMPS 1.4 wiring set]] | *[[http://www.2printbeta.de/product_info.php?language=en&products_id=66|RAMPS 1.4 wiring set]] | ||
| + | *[[http://www.2printbeta.de/product_info.php?language=en&products_id=156 |ATX power supply]] | ||
| * A hotend: either a [[http://www.2printbeta.de/product_info.php?language=en&products_id=121|arcol.hu 4.0]] or a [[http://www.2printbeta.de/product_info.php?language=en&products_id=118|J-head]] hotend | * A hotend: either a [[http://www.2printbeta.de/product_info.php?language=en&products_id=121|arcol.hu 4.0]] or a [[http://www.2printbeta.de/product_info.php?language=en&products_id=118|J-head]] hotend | ||
| + | Also recommended: [[http://www.2printbeta.de/product_info.php?language=en&products_id=155| A heated bed kit]] | ||
| ===== Building the 3D printer ===== | ===== Building the 3D printer ===== | ||
| For building up the Wallace 3D printer, you can take a look at the following [[build-wallace|page]] | For building up the Wallace 3D printer, you can take a look at the following [[build-wallace|page]] | ||
