Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
printupy [2014/09/16 15:13]
bonsaibrain [Troubleshooting]
printupy [2018/07/20 16:08] (current)
Line 54: Line 54:
 Also the layers doesn'​t stick together, if soft PLA is printed to fast. Also the layers doesn'​t stick together, if soft PLA is printed to fast.
 When printed with the right speed and temperature it is possible to print rubber stamps or RC tires. When printed with the right speed and temperature it is possible to print rubber stamps or RC tires.
-It sticks perfect to warm (60°C) glass. UHU is not recommended,​ because it sticks ​to well to it.+It sticks perfect to warm (60°C) glass. UHU is not recommended,​ because it sticks ​too well to it.
  
 ===== Laywoo-D3 ===== ===== Laywoo-D3 =====
Line 149: Line 149:
  
 **__Resolution:​__** **__Resolution:​__**
-This is a problem which only occurs at elevated temperatures. The fans are very powerful. Especially for PLA you need very good cooling. For ABS or Nylon you don't need that, so it is recommended to reduce the speed of the fans. You can either set it directly on the menu under "​tune->​fan speed" (fan2 speed) or "​contol->​temperature->​fan speed" (fan2 speed) or you adjust the start gcode in slic3r (printer settings->​custom G-code) by adding a value from 0 to 255 after the "​S"​ in "M106 P0 S200" / "M106 P1 S200", where 255 is full speed and 0 is fan off.+This is a problem which only occurs at elevated temperatures. The fans are very powerful. Especially for PLA you need very good cooling. For ABS or nylon you don't need that, so it is recommended to reduce the speed of the fans. You can either set it directly on the menu under "​tune->​fan speed" (fan2 speed) or "​contol->​temperature->​fan speed" (fan2 speed) or you adjust the start gcode in slic3r (printer settings->​custom G-code) by adding a value from 0 to 255 after the "​S"​ in "M106 P0 S200" / "M106 P1 S200", where 255 is full speed and 0 is fan off.

printupy.1410873186.txt.gz · Last modified: 2018/07/20 16:07 (external edit)