Differences

This shows you the differences between two versions of the page.

Link to this comparison view

optoendstop-beta [2018/07/20 16:08]
optoendstop-beta [2018/07/20 16:08] (current)
Line 1: Line 1:
 +====== Optoendstop-beta ======
 +
 +This page contains information about the optoendstop-beta,​ the optical endstops you can buy at 2PrintBeta.
 +
 +===== Version 1 =====
 +
 +{{endstop:​endstop-beta-v1.png?​direct&​400|}}
 +
 +This endstop is based on the reprapsource optoendstop (http://​reprapsource.com/​oe-r1?​lang=en). ​
 +
 +The following improvements/​changes where made.
 +
 +  * Removed the screwterminals leaving only the pinheaders.
 +  * Rerouted the board for a single layer board.
 +  * Improved routing of the signals
 +\\
 +The optoendstop design is licenced under the GLP2.0. You can find the design dokuments here: 
 +
 +{{endstop:​endstop-beta-v1-schematic.png?​direct&​200|}}
 +{{endstop:​endstop-beta-v1-board.png?​direct&​|}} ​
 +
 +{{endstop:​opto_endstop_beta_v1.sch|Eagle Schematic}}
 +{{endstop:​opto_endstop_beta_v1.brd|Eagle Board}}
 +
 +===== Version 2 =====
 +
 +For version two of the optical endstop, we replaced the 3 through hole resistors with smd versions on the other side. And due to this the board is now much smaller.
 +
 +{{endstop:​endstop-beta-v2-schematic.png?​direct&​200|}}
 +{{endstop:​endstop-beta-v2-board.png?​direct&​200|}} ​
 +
 +It is ofcourse also licenced under GPL2.0. You can find the design documents here:
 +
 +{{endstop:​opto_endstop_beta_v2.sch|Eagle Schematic}}
 +{{endstop:​opto_endstop_beta_v2.brd|Eagle Board}}
  

optoendstop-beta.txt ยท Last modified: 2018/07/20 16:08 (external edit)