Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
build-arcol-4.0-hotend [2011/12/03 14:22]
bonsaibrain
build-arcol-4.0-hotend [2018/07/20 16:08] (current)
Line 15: Line 15:
 Then you screw the stainless steel connection tube inside the heatsink block. \\ Then you screw the stainless steel connection tube inside the heatsink block. \\
 {{:​hotend:​4-heatsinksteel-bolt.jpg?​direct&​400|}} \\ {{:​hotend:​4-heatsinksteel-bolt.jpg?​direct&​400|}} \\
-You should use a wrench or pliers to be sure it is firmly mounted. \\ 
-{{:​hotend:​wrench.jpg?​direct&​400|}} \\ 
 At the other side insert the grub screw to secure the PTFE-tube inside. \\ At the other side insert the grub screw to secure the PTFE-tube inside. \\
 {{:​hotend:​5-heatsinkgrubscrew.jpg?​direct&​400|}} \\ {{:​hotend:​5-heatsinkgrubscrew.jpg?​direct&​400|}} \\
Line 28: Line 26:
 Finally you screw the previous assembled nozzle/​heater/​thermistor-block onto the heatsink and put thermoresistant isolation around the wiring of the hotend. \\ Finally you screw the previous assembled nozzle/​heater/​thermistor-block onto the heatsink and put thermoresistant isolation around the wiring of the hotend. \\
 {{:​hotend:​11-nozzleheatsink.jpg?​direct&​400|}} \\ {{:​hotend:​11-nozzleheatsink.jpg?​direct&​400|}} \\
-Be sure the hotend is screwed on tight or else the hot-end will block or leak plastic. The steel-bolt has to cut the winding into the bottom of the nozzle. ​Use a wrench for doing this. \\+Be sure the hotend is screwed on tight or else the hot-end will block or leak plastic. The steel-bolt has to cut the winding into the bottom of the nozzle. ​ \\
 {{:​hotend:​13-nozzlebolt-tight.jpg?​direct&​400|}} \\ {{:​hotend:​13-nozzlebolt-tight.jpg?​direct&​400|}} \\
 +You should use a wrench or pliers to be sure it is firmly mounted. \\
 +{{:​hotend:​wrench.jpg?​direct&​400|}} \\
 It looks like this, if it is too loose: \\ It looks like this, if it is too loose: \\
 {{:​hotend:​14-nozzlebolt-loose.jpg?​direct&​400|}} ​ \\ {{:​hotend:​14-nozzlebolt-loose.jpg?​direct&​400|}} ​ \\

build-arcol-4.0-hotend.txt ยท Last modified: 2018/07/20 16:08 (external edit)